Support

Knowledge Base  /  Product Tours

Room Alert 3 Wi-Fi Product Tour

Welcome to the Room Alert 3 Wi-Fi


The Room Alert 3 Wi-Fi is AVTECH’s compact and economical wireless solution for IT and facilities environment monitoring. It can be installed in areas without a standard Ethernet connection.


Click on any feature to see more information about this model.

Room Alert 3 Wi-Fi
Power Port Link & Status LEDs Reset Button Switch Sensor Port Digital Sensor Port

Power Port

This port accepts AVTECH's 5V power adapter (shown above) to power the Room Alert 3 Wi-Fi. There are models for each and every country.

Link & Status LEDs

The Link and Status LEDs show the state of your Room Alert 3 Wi-Fi.

  • The Status (S) LED winks momentarily when the unit is first powered on.
  • The Link (L) LED is lit solid when the Room Alert 3 Wi-Fi is connected to your wireless network.

Reset Button

The reset button resets your Room Alert 3 Wi-Fi to defaults. It clears out any custom settings such as your wireless network connection and static IP address.

Switch Sensor Port

This port accepts a switch sensor or dry contacts on a device such as a UPS. AVTECH offers switch sensors for every critical environment factor, such as powerflood (shown above), smokeair flow and more.

Digital Sensor Port

This standard RJ-11 port accepts an AVTECH digital sensor.

Compatible digital sensors include:

Facebooktwitterredditpinterestlinkedinmail
Room Alert is Made in the USA, ships worldwide from our locations in the US and EU, and has been protecting facilities since 1988.

You may find Windows Command Prompt at the following path:

  • Windows 7 & 8
    Start--> All Programs--> Accessories--> Command Prompt
  • Windows 10
    Start--> All Apps--> Windows System--> Command Prompt

To run Windows Command Prompt as an administrator:

  • Windows 7 & 8
    Right-click on Command Prompt and select Run as administrator.
  • Windows 10
    Right-click on Command Prompt, select More and then select Run as administrator.

Example Polling Method Properties saved in Orion SolarWinds:

If you are using this client, you should configure the general SNMPv3 Credentials, but leave the Read / Write SNMPv3 Credentials section blank.

Room Alert Link- Supported Firmware Updates



Current S modelsCurrent E models
Room Alert 32SRoom Alert 32E
Room Alert 12SRoom Alert 12E
Room Alert 4E
Room Alert 3E

Room Alert Manager - Compatible Devices

The latest version of Room Alert Manager supports only the devices below.

It does not support any legacy Room Alert or TemPageR models.

Current S modelsCurrent E models
Room Alert 32SRoom Alert 32E
Room Alert 12SRoom Alert 12E
Room Alert 3SRoom Alert 4E
Room Alert 3E
Room Alert 3W