Knowledge Base  /  Frequently Asked Questions  /  RoomAlert.com  /  Room Alert Link

How To Access Link’s Local Web Interface

Your Room Alert Link has a local web interface that you can access if you’re on the same network as Link’s host computer.

You may wish to access Link’s local web interface to:

  • View a list of discovered devices
  • Update Link’s discovery settings
  • Update Link’s authorization key

To open Link’s local web interface, follow the instructions below.

Access Link from the host computer

To access Link’s local web interface from its host computer, simply type localhost:8989 (by default) into your web browser’s address bar, as shown below.

Access Link from a different computer on the network

To access Link’s local web interface from a different computer on the network, first open Inbound port 8989 (by default) on Link’s host computer.

Then type <IP address of host system>:8989 into your web browser’s address bar. An example is shown below.

Facebooktwitterredditpinterestlinkedinmail
Room Alert is Made in the USA, ships the same day, and has been protecting facilities in over 185 countries since 1988.

Example Polling Method Properties saved in Orion SolarWinds:

If you are using this client, you should configure the general SNMPv3 Credentials, but leave the Read / Write SNMPv3 Credentials section blank.

Room Alert Link- Supported Firmware Updates



Current S modelsCurrent E models
Room Alert 32SRoom Alert 32E
Room Alert 12SRoom Alert 12E
Room Alert 4E
Room Alert 3E

Room Alert Manager - Compatible Devices

The latest version of Room Alert Manager supports only the devices below.

It does not support any legacy Room Alert or TemPageR models.

Current S modelsCurrent E models
Room Alert 32SRoom Alert 32E
Room Alert 12SRoom Alert 12E
Room Alert 3SRoom Alert 4E
Room Alert 3E
Room Alert 3W