What Triggers A Push To RoomAlert.com

On firmware v1.0, Room Alert MAX Base Stations ONLY push data hourly. The next firmware release will incorporate push triggers.

Room Alert Monitors with push to RoomAlert.com enabled automatically update your Room Alert account with sensor data at defined intervals. Please see our FAQ, How To Enable/Disable Push To RoomAlert.com, for a list of models and firmware versions that have this feature.

By default, push to RoomAlert.com happens at these times:

• When your unit first boots (and every time it reboots).

• When an external digital sensor is first connected or disconnected.

• When your unit’s internal or an external temperature sensor reading rises or falls by 2 whole degrees Celsius.

• When your unit’s internal or an external humidity sensor reading rises or falls by 5 percent relative humidity.

• When any switch sensor on your unit changes state from open to closed (and vice versa).

• When a Digital Active Power sensor reading changes from Power Detected to No Power Detected (and vice versa).

• When a Digital Temperature & Air Flow sensor reading rises or falls by 0.75 meters per second.

• Room Alert S models only: When a Digital Extreme Temperature Sensor detects a fault.

• Room Alert 4E only: when a ping changes from reachable to unreachable (and vice versa).

• When your unit’s built-in or an external analog sensor rises or falls by 0.25 volts.

• When any Light Tower or relay is manually toggled on/off.

• Room Alert 32 only: when the power status changes from Main Power to Battery Backup (and vice versa).

• Once an hour after the last successful push, regardless of the state of any of your unit’s sensors.