What Triggers A Push To RoomAlert.com

Room Alert Monitors with push to RoomAlert.com enabled automatically update your Room Alert account with sensor data at defined intervals. Please see our FAQ, How To Enable/Disable Push To RoomAlert.com, for a list of models and firmware versions that have this feature.

By default, push to RoomAlert.com happens at these times:

• When your unit first boots (and every time it reboots).

• When an external digital sensor is first connected or disconnected.

• When your unit’s internal or an external temperature sensor reading rises or falls by 2 whole degrees Celsius.

• When your unit’s internal or an external humidity sensor reading rises or falls by 5 percent relative humidity.

• When any switch sensor on your unit changes state from open to closed (and vice versa).

• When a Digital Active Power sensor reading changes from Power Detected to No Power Detected (and vice versa).

• When a Digital Temperature & Air Flow sensor reading rises or falls by 0.75 meters per second.

• Room Alert S models only: When a Digital Extreme Temperature Sensor detects a fault.

• Room Alert 4E only: when a ping changes from reachable to unreachable (and vice versa).

• When your unit’s built-in or an external analog sensor rises or falls by 0.25 volts.

• When any Light Tower or relay is manually toggled on/off.

• Room Alert 32 only: when the power status changes from Main Power to Battery Backup (and vice versa).

• Once an hour after the last successful push, regardless of the state of any of your unit’s sensors.