Knowledge Base / Frequently Asked Questions / Room Alert
In the Room Alert Monitor web interface, the following icons indicate the status of each of the unit’s individual sensors:
– A gray circle or no circle means there are no thresholds configured on the Room Alert Monitor for that sensor.
– A check mark or green circle 
means the sensor is in a clear state: it has not passed any threshold configured on the Room Alert Monitor.
– An X or red circle 
means the sensor is in an alarm state: it has passed a threshold configured on the Room Alert Monitor.
To view the sensor icons:
1. Open your Room Alert Monitor’s web interface. You may open the interface using Device Discovery, Device ManageR, or your account at RoomAlert.com. You may also type the IP address of the unit directly into the address bar of your web browser.
2. The icons will appear next to the sensors in the Status page, as shown below:
In this image, you can observe the following:
– The Internal Sensor does not have a threshold configured on the Room Alert Monitor.
– Ext Sensor 1 is in a clear state.
– Switch Sen 1 is in an alarm state.
We'd love to talk with you about your monitoring needs. Contact one of our Product Specialists for a free consultation.
You may find Windows Command Prompt at the following path:
To run Windows Command Prompt as an administrator:
If you are using this client, you should configure the general SNMPv3 Credentials, but leave the Read / Write SNMPv3 Credentials section blank.
| Current S models | Current E models |
|---|---|
| Room Alert 32S | Room Alert 32E |
| Room Alert 12S | Room Alert 12E |
| Room Alert 4E | |
| Room Alert 3E | |
| Current S models | Current E models |
|---|---|
| Room Alert 32S | Room Alert 32E |
| Room Alert 12S | Room Alert 12E |
| Room Alert 3S | Room Alert 4E |
| Room Alert 3E | |
| Room Alert 3W |
